• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Mitsubishi Ki-46 III Dinah for Fs9

S

Shessi

SOH-CM-2025
Hi Folks,
Just finished and uploaded the new model Dinah III recon ac to the library.

Cheers

Shessi
 
Thanks for all of your hard work, Shessi! Looking forward to downloading her, and taking a spin!

Alan :applause:
 
A BLAST from my CFS2 days! A very unusual design, looks sleek and fast.... I'm going to have a go with "Dinah", I'll report back. Thanks Shessi! :encouragement::very_drunk:

BB686:US-flag:
 
Thank's :applause:
Downloaded and tested
Nice textures
Seems to me "noze heavy" (even with full trim up I must use elevator for keep it level)
 
Here's a new 2D panel for it...

Fantastic work as usual Shessi :applause::applause:

Here is a little plastic surgery for a very, very nice job on the Dinah...

Available as usual, comment...suggestions welcome... ("clean" or with throttles and yoke)



21568021619_1e7d687ffb_o.jpg




:ernaehrung004:



G..
 
Nice work G, a smart alternative, go on give it a go?! ;)

Nav,
Strange as the testers didn't mention anything and I've not experienced that at all. I'm certainly not saying it's perfect, but possibly your joystick needs re-calibration? And something that some people forget to check is the biased control settings within the sim itself, they may be out.

Cheers

Shessi
 
Thanks H,
It's one of those ac I remember making as a kit and seeing in mags, there is a CFS2 one and Alpahsim's for FS2000 but neither show up well in Fs9, so one I had to make. Fast and good looking!

As I've said before, it wouldn't be possible though without the initial workings and generosity of good ol' Alphasim. Thanks AS!

Cheers

Shessi
 
Work fine now after I corrected my typo in this stance :dizzy:
I modified this ..
elevator_trim_effectiveness=1
to this
elevator_trim_effectiveness=0
instead of this
elevator_trim_effectiveness=0.9
Now I can level flight with no problems :adoration:
 
Gaucho, that panel looks great. Upload it here when you're satisfied with it and I'll certainly use it.
 
Many thanks to Shessi for this great aircraft, much appreciated. And to Gaucho, great looking panels. Please consider uploading them.

Regards,

Taff
 
You must log in or register to reply here.
Back
Top