• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Scenery repair help please....

M

Miggers

Members +
Flap over,I've managed to sort it out.


Gents,your help please.

I've been messing about with my RAF Valley scenery in AFCAD and somehow have managed to move one of the runways
(14/32) off it's alignment axis and can figure how to "rotate" it back.

It's part of the Just Flight series,short of removing and reinstalling the package,is there a way to rotate it back?

I went in there because the current "alignment" is 13/31,so wanted to rotate it to that and close off 08/26 as it's only now used as a taxiway plus bring the TACAN from it's old location off airfield to it's new on airfield location.

I managed to move the TACAN and closed 08/26,but can't get 14/32 or 13/31 back into position at all.........
 
I think you have achieved something nobody has been able to do so far. I think re-installing will be the only way to go.

Success,
Huub
 
huub vink said:
I think you have achieved something nobody has been able to do so far. I think re-installing will be the only way to go.

Success,
Huub
Click to expand...
Huub,I managed to get it back into position using AFCAD of all things.
I just checked the "real" alignment, repositioned to those numbers and the thing popped right back into place.
 
You must log in or register to reply here.
Back
Top