• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Specific Military AI Issue

S

SeanTK

Charter Member
Hello,

I am aware that a few people here seem to have an interest in the Dassault Mirage series of fighter aircraft, and upon searching through some past posts, are familiar with [FONT=arial,geneva,helvetica][SIZE=-1][FONT=arial,geneva,helvetica][SIZE=-1]Nancy Ochey (LFSO) Airbase.

I have been trying to get the "[/SIZE][/FONT][/SIZE][/FONT][FONT=arial,geneva,helvetica][SIZE=-1][FONT=arial,geneva,helvetica][SIZE=-1]Nancy Ochey (LFSO) AI Package" available in the following link to work, without success:
http://www.mirage4fs.com/scenery_traffic.html

It should be pretty straight forward to do, and I am familiar with manually installing AI packages, but my airbase still lacks the AI Mirages. (It's for the 2006 version of the scenery.)

Has anyone else had success getting this traffic to work?

Note: All required elements for the package are available on that website. When looking for the base aircraft file, you may have to select "View all Mirage 2000s" on that page.

Thanks for the assistance,

-Sean

[/SIZE][/FONT][/SIZE][/FONT]
 
There seems to come a replacing aircraft.cfg with the AI-traffic files ... BUT that doesn't include anything else but [fltsim.xx] part of the file. Are you sure that you haven't replaced the original (whole) aircraft.cfg with that inadequate one?

I'll try to install that traffic too and see if that works with me.

Pekka
 
Which Ai Mirages does that package have? Are they the Fernando Martinez' models?

....check the % numbers in the flightplans and make sure you have your traffic sliders set higher than the percentage shown....sometimes the flightplans are set for the slders to be at 100% and if you have your traffic sliders lower than that they will not show up...
 
The new issue is that they are showing up for a split second when the scenario first loads, but then disappear right away. If the sim starts in a paused state here, you can see the Mirages sunk halfway into the ground.
If you want to bounce more ideas and get a better sense of where I am at with this, I am running a parallel thread here:
http://205.252.250.26/cgi-bin/yabb2/YaBB.pl?num=1269235975

EDIT UPDATE: It appears to be an issue with some severely messed up contact points on the AI model. I'm going to do some tweaks and report back later.
 
You must log in or register to reply here.
Back
Top