• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

Lockheed Jetstar II

Thanks a lot

Perfect function very well

Where to put

Content of file (4 xml files ) to panel/JS folder

in panel.cfg you replace the entries JS_ITT_1-A with --> JS_ITT_1-B

Best regards

Roland
 
Just wanted to give a thumbs up to Roland and everyone else that is enthusiastically trying to give the long awaited JSII a new life. It is also wonderful to see it become a community project.

Thank to all of you

Best
Jim
 
Thanks for making the gauges functional - :encouragement:

When/Why would you want to hit the reset button?

Capture.jpg
 
My left side ADI has always looked good and worked. Think there is a problem with the right seat ADI.
 
I assume both ADI gauges are out for repairs (redo)? Currently blank (non functional) -
Click to expand...

Also note from the real panel photo, these engine gauges look like they map more accurately to the ones in Fraser McKay 2D panel? See for example at post # 193 above.
 
Just wanted to give a thumbs up to Roland and everyone else that is enthusiastically trying to give the long awaited JSII a new life. It is also wonderful to see it become a community project.

Thank to all of you

Best
Jim
Click to expand...

Well Jim, for someone who hoped and waited for this aircraft for about the past ten years I have been flying the slipper tanks off her for the past week or so as you might imagine. Your generosity made it happen so we all are very grateful to you. This really is fun!
 
gray eagle said:
Thanks for making the gauges functional - :encouragement:

When/Why would you want to hit the reset button?
Click to expand...
The needle stops at the highest reading achieved and stays there until reset. Same logic as on a G-meter. At the end of the flight (or for other reasons) the crew can log the max temp on the flight. Maybe for general maintenance tracking, or if limits were exceeded, by how much.

Think how hard it is in a busy takeoff to remember the exact overtemp reading on takeoff if it happens. Thes airplanes likely did not record that much info on old flight recorders.
 
I have a Dedicated FSX (exterior only) model that I have reworked. I'll try to get it up here this afternoon after a few more checks in the sim.

Added the following:

Hard coded landing and taxi lights and respond to the proper switches.
Enabled reflective textures using the standard alpha channel method.
Specular textures using the normal (diffuse) textures
Reworked glass textures that are reflective.
A few model animations tweaked (mostly animation naming)


I'll try to get it posted by this evening (Eastern Time)

P3D3-2021-nov-7-004.jpg
 
You must log in or register to reply here.
Back
Top