• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Server side Maintenance is done. We still have an update to the forum software to run but that one will have to wait for a better time.

SSW Models

Status
Not open for further replies.
SSW Dedicated Configurator

Hi Emanuele,

Thank you for the advise to always use the SSW dedicated configuration panel to adjust (raise/lower) my SSW aircraft fuel. I have tried to lower my total weight (F-104S/ASA) to less that 16,100 lbs by using the SSW Configuration Panel. I selected the wing tip tanks and lowered their fuel to 6 lbs fuel in each (mouse over the "refuel" under those tanks to see fuel in them). I lowered the fuel in my CL (fuselage) tank (selected "Refuel Fun", and then "Refuel" under the CL tank). I can NOT get the total weight under 16,586 lbs. - which is higher than the maximum landing weight. Is there any way to lower the internal fuel so that the total weight is less than about 16,000 lbs? I also looked for your "yellow button" on the panel that will manually initialize (in case I ever need it). I can not find it on my SSW Configuration Panel. Where is it located?

Best regards, Bill
 
Wings of Gold said:
Hi Emanuele,

Thank you for the advise to always use the SSW dedicated configuration panel to adjust (raise/lower) my SSW aircraft fuel. I have tried to lower my total weight (F-104S/ASA) to less that 16,100 lbs by using the SSW Configuration Panel. I selected the wing tip tanks and lowered their fuel to 6 lbs fuel in each (mouse over the "refuel" under those tanks to see fuel in them). I lowered the fuel in my CL (fuselage) tank (selected "Refuel Fun", and then "Refuel" under the CL tank). I can NOT get the total weight under 16,586 lbs. - which is higher than the maximum landing weight. Is there any way to lower the internal fuel so that the total weight is less than about 16,000 lbs? I also looked for your "yellow button" on the panel that will manually initialize (in case I ever need it). I can not find it on my SSW Configuration Panel. Where is it located?

Best regards, Bill
Click to expand...

Hi Bill..
The F 104 has a GW with internal tank filled of about 21600lbs in a clean configuration. For this reason if you empty the internal tank you get a GW of about 16000lbs, which is totally correct. Where did you read that the maximum weight for landing should be less than 16000lbs?

The button I mean, is the "Cold&Dark" one ;)
Regards
Emanuele
 
Wings of Gold said:
Hi Emanuele,

Thank you for the advise to always use the SSW dedicated configuration panel to adjust (raise/lower) my SSW aircraft fuel. I have tried to lower my total weight (F-104S/ASA) to less that 16,100 lbs by using the SSW Configuration Panel. I selected the wing tip tanks and lowered their fuel to 6 lbs fuel in each (mouse over the "refuel" under those tanks to see fuel in them). I lowered the fuel in my CL (fuselage) tank (selected "Refuel Fun", and then "Refuel" under the CL tank). I can NOT get the total weight under 16,586 lbs. - which is higher than the maximum landing weight. Is there any way to lower the internal fuel so that the total weight is less than about 16,000 lbs? I also looked for your "yellow button" on the panel that will manually initialize (in case I ever need it). I can not find it on my SSW Configuration Panel. Where is it located?

Best regards, Bill
Click to expand...

The yellow "button " is the cold and dark button as you can see here

 
LAU-10 bug?

Hello SSW Team,

LAU-10 bug?
I noticed when I use the rocket pod LAU-10 it after shot not eliminated the rocket count
The last rounds disappears LAU-10
Is it a bug?

azNSJEr.jpg


Zsolt
 
Just a question (but I have no idea than its a model of F-84F of SSW or something else). Last two times I noticed than after long flight on Thunderstreak (solo model, more than 40 minutes of flying) I heared "windows error sound" few times but without any messages, pause of FSX ect.

Its a something like recurrent sound of error only. Someone noticed too same or its my phobia only? ; >
 
YoYo said:
Just a question (but I have no idea than its a model of F-84F of SSW or something else). Last two times I noticed than after long flight on Thunderstreak (solo model, more than 40 minutes of flying) I heared "windows error sound" few times but without any messages, pause of FSX ect.

Its a something like recurrent sound of error only. Someone noticed too same or its my phobia only? ; >
Click to expand...

Sounds like the FSUIPC OOM (Out Of Memory) warning, aka the sound of death. The longer you fly and the more scenery is loaded in the sim, the more VAS memory is used and when you are reaching the limit, you get the warning sound and your flight may end with a CTD. There is lots of reading and advice on this topic on the internet. Some addons are more memory hungry than others due to complex models/VC's, hi res textures etc. One of the solutions is to reduce scenery settings.
 
Thank You, I will investigate it :wavey:.

The flight is continued but actually, as I took a late end of flight in FSX the simulator had CTD in the end.
 
hschuit said:
Sounds like the FSUIPC OOM (Out Of Memory) warning, aka the sound of death. The longer you fly and the more scenery is loaded in the sim, the more VAS memory is used and when you are reaching the limit, you get the warning sound and your flight may end with a CTD. There is lots of reading and advice on this topic on the internet. Some addons are more memory hungry than others due to complex models/VC's, hi res textures etc. One of the solutions is to reduce scenery settings.
Click to expand...

You can monitor the VAS usage using this Application http://technet.microsoft.com/en-us/sysinternals/bb896653.aspx

3 question
1 : How about your fsx.cfg? can you send it to me please pvt ?
2 : Dll.xml ? Can you send it to me?
3: Scenery.cfg? Can you send it to me ? ( c:\program data\microsoft\fsx )

Thank you. If possible to send me also your rig ( cpu , graphic card , sysop etc )

Thank you
Andrea
 
Lr-25

F-104G:

The LR-25 missile total bug

- first shot I not see the shooting
- the second shot the rocket POD disappears

:banghead: :dizzy:
 
Just as reminder for All.
We have a support forum for all the questions regarding our models and for bugs report. In this way it is easier for us to have a situation awarness about all the problems and bugs.
Thanks to all ;)
Emanuele
 
Pluto12 said:
Just as reminder for All.
We have a support forum for all the questions regarding our models and for bugs report. In this way it is easier for us to have a situation awarness about all the problems and bugs.
Thanks to all ;)
Emanuele
Click to expand...

Why? There I get an answer to the problem? :biggrin-new:

Zsolt
 
And I just recently heard from a friend who had his computer die on him, that in order to reïnstall his product, he had to buy a new license...

In other words, they "made him an offer he couldn't refuse"...

Not so nice...
 
I replaced my machine last January and you need a new register entry for each aircraft. Install the aircraft, load once and a .ssw file appears in the FSX main directory. Email that to SSW and a new register file will be sent back free. AFAIK....!

DaveQ
 
I've replaced 2 times different components of my pc, and every time, in few hours, I've received the new key files, free of charge. If you don't change your simulator from FSX/P3D 1.x to P3D 2.x you don't need to buy again anything, it's clearly wrote in their site!
 
DaveQ said:
I replaced my machine last January and you need a new register entry for each aircraft. Install the aircraft, load once and a .ssw file appears in the FSX main directory. Email that to SSW and a new register file will be sent back free. AFAIK....!

DaveQ
Click to expand...

This is not true!
The email system is not working!

SSW:

you have buyed a single licence key for your pc .

You have request the second activation for the second pc . For the second pc you have to buy a license ( 50% off ) .

For the 3rd pc is the same , you have to buy a new license ( 50 % off ) .

For the 4th Pc you have to buy a new license but without discount.

In case of you have to reinstall win7 is different , you have a valid license and we can reactivate it without problem's for the 1st , 2nd , 3rd , 4th pc.

We always check hw info and we know if you are installing license in one your pc or if you're installing on a new pc ( not your or new pc ) .

In case of one of the 2,3,4 pc demaged or have been substituted just inform previous, and we can find a solution.

I have buyed a license for the ASN , for my pc n1 , for my pc n2 , i have payed for a new license FULL PRICED without any discount, Same for the VRSf18 , same for the PMDG .

This is only an example, but that's is.

This fair business policy? :wiggle:
 
cortomalteseit said:
I've replaced many times different components of my pc, and every time, in few hours, I've received the new key files, free of charge. If you don't change your simulator from FSX/P3D 1.x to P3D 2.x you don't need to buy again anything, it's clearly wrote in their site!
Click to expand...

That's interesting, I'm waiting for a week for the second key
How do you do it?
 
From SSW:

"Hi Zsolt,
what we need to do to convince you to use the help desk?
we have written too many times that we can not provide support via email,
we won't not respond to your email'sany more.
Please use the help desk.
/SSW
BTW
which second key are you meaning for ?
we receive just a payment and a request for the F-84F activation key which has been processed and sent.
No request nor payment received for a second key."

I have to say, the Help Desk does not help!
 
Status
Not open for further replies.
Back
Top