• There seems to be an uptick in Political comments in recent months. Those of us who are long time members of the site know that Political and Religious content has been banned for years. Nothing has changed. Please leave all political and religious comments out of the forums.

    If you recently joined the forums you were not presented with this restriction in the terms of service. This was due to a conversion error when we went from vBulletin to Xenforo. We have updated our terms of service to reflect these corrections.

    Please note any post refering to a politician will be considered political even if it is intended to be humor. Our experience is these topics have a way of dividing the forums and causing deep resentment among members. It is a poison to the community. We appreciate compliance with the rules.

    The Staff of SOH

  • Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.

    Post 16 Update

    Post 17 Warning

T-38A Is OUT!

Sorry but even though you post here, we can't do any support until you post it in the closed forums at our site.

Thanks for your purchase...
 
peter12213 said:
Still havent bought this bird, why ?? who knows, maybe because it's the 4th F5 variant I would buy, but This looks awesome but I have enough skill to skip this and Hit the Strike Eagle, with both Talons on the Warthog, walk the throttles baby!!! :salute:
Click to expand...

Peter, I promise you this is NOT another F5 variant. I have all three of the F5s and this plane is as close to the real plane as you will likely get in FSX. More than one, while flying the T-38A, I have felt deja vu. It was like I was back in the real airplane. The only thing missing was the pucker factor.

One night I flew a into Mac Dill, AFB in Tampa, FL at night. I was flying IFR and you know how FSX ATC can direct you all over the sky. Well, I flew in off the water and could not pick out the base from all the other lights. I had to go around and get re-vectored. Again I couldn't find the runway, until the very end. I managed to land.

At that point I was sweating and grateful to finally be on the ground. That was pretty real to me.
 
Message to all "topgun" repainters :

Here is an other interesting T-38 repaint project :

http://www.airliners.net/photo/Turk...39261/L/&sid=a48a2903547c9354e60c392b24178024

T-38 of : 2nci JÜUO / 121 Tekamül Filosu "Ari ( Bee )" of the
"Turk Hava Kuvvetleri".

This is the advance "Lead-In Fighter" unit of the Turkish Air Force ( THK )
located at Izmir - Cigli Air Base ( LTBL ).

There is a lot of other photos on Airliners.Net about these T-38A/M
:mixedsmi:
VaporZ
 
VaporZ said:
Message to all "topgun" repainters :

Here is an other interesting T-38 repaint project :

http://www.airliners.net/photo/Turk...39261/L/&sid=a48a2903547c9354e60c392b24178024

T-38 of : 2nci JÜUO / 121 Tekamül Filosu "Ari ( Bee )" of the
"Turk Hava Kuvvetleri".

This is the advance "Lead-In Fighter" unit of the Turkish Air Force ( THK )
located at Izmir - Cigli Air Base ( LTBL ).

There is a lot of other photos on Airliners.Net about these T-38A/M
:mixedsmi:
VaporZ
Click to expand...

Note that stencils instructions on Turkish T-38 are mostly in Turkish
language or bilingual.

"Rescue/Kurtar" for the safety yellow arrow
and
"Tehlike" for the ejection seat warning triangle

Take a look here :
http://www.airfighters.com/photo/80287/L/Turkey-Air-Force/Northrop-T-38A-Talon/23611/
:mixedsmi:
VaporZ
 
The T-38A SP is now out. For all those that purchased it from our site, feel free to just reinstall it.

For those that purchased it from other sites, please go to where you got it and get it...

(did that make sense?)

We did a lot of work on this to make it nicer than it was...

And all of the bugs that we could kill were ... uh.. killed!
 
how do i reinstall the SP?

i downloaded the new v2 and clicked in the reinstall but using the original key file with the paypal code give me that the password is incorrect???

is correct to use the first version purchase data? is not working...
 
Can we get a changelog for what's new in the service pack? I wasn't able to find one in the docs, and I haven't seen any differences in flying the aircraft?
 
krazycolin, just two things:
- I can´t find the register buttom for Milviz forum. Can you help me?
- As i can´t register now, just a little question in here: Do i have to uninstall the t38 or just delete the folder to install the new one? I can´t find a uninstall for it.

Thanks! :salute:
 
if you read the manual (or the quickstart) it tells you how to register... (info at milviz dot com)

Just install over. Should be fine.
 
Can´t find any information about registering in the forums in this two documents:
- Milviz T-38A POH.pdf
- Quick guide T38.pdf

But managed to do a correct install myself. Thanks! :salute: :salute:
 
CHANGE LOG:
08/16/11
=========
1. Restored original pilot figures

2. Fixed the hesitating main wheels

CHANGE LOG:
08/12/11
=========

2. Updated the exterior texture for inside of the engine intakes on all liveries.

3. Modified code to inhibit speed brake extension with no hydraulic pressure.

4. Added safety wire on pilot's left side console for the engine trim adjusters.

CHANGE LOG
08/05/11
=============
1. CN2 >100% *AND* power lever position > 85% to trigger the AB's. I've also set AB off to be CN2 < 100% *OR* power

lever position < 85%.

2. I've also modified the "clack" sound to play in both directions. IOW, when leaving AB you will hear a "clack" to

let you know you're back at MIL power.

3. I've also added some "time of day" checks to reduce the AB "flames" during the daytime.

4. Installed Chuck's animated pilots.

5. Updated the T-38A's external sounds with Fabio's revised .wav files.

CHANGE LOG:
07/31/11
=========
1. Added missing aft panel mesh for the exterior model.

2. Add limit code to the slip indicator.

3. Removed visor shadows from the Thunderbird pilot's helmets.

CHANGE LOG
07/27/11
---------------
1. Includes Bernt's latest FDE (A3)

2. Includes latest Macro files

3. Fixed the COM radio tuning, expanded tooltip to show all three decimals

4. Fixed the two yoke buttons that were "floating"

5. Moved the fwd mirrors to the canopy frame in exterior and interior models

6. Shifted the audio rumble sounds 0.1 unit "ahead" to delay onset of "massive rumble" just above 0.6 units.

CHANGE LOG
07/23/11
---------------
1. YD Switch is now just a dummy, it moves and makes noise.

2. Reversed animation for the Speedbrake slider; installed same slider in aft cockpit.

3. Positively lock nose gear steering when wheels off ground.

4. Fixed shroud in aft canopy mechanism

5. Anti-Ice system now operative and fixed tooltip

6. CRS knob's tooltip will now indicate correct degrees based on mode switch (OBS1, OBS2)


CHANGE LOG
07/20/11
==========
1. Helmet Visors are "up" at night/dawn/dusk, "down" during daytime. Removed the "shadows" from the standard white

helmet texture.

3. Cloned fwd AoA needle for aft panel.

4. Disabled "Yaw Damper" while on ground. If 3d switch is "on" the sim command for "Yaw Damper" is activated.

5. Installed Bob's revisions to the Gear Warning and extend/retract logic, updated trimmed gearup.wav file, revised

aircraft.cfg extension times for gear.

6. Installed Bob's revised "Buffet Sound" and "Buffet System" logic. Tests fine for me here. I have of course

retained the original logic, "just in case..."

7. Reworked the fwd speedbrake control to make it a "slider" rather than a "rocker." If this is okay, then I'll

clone/past to the aft control as well.

8. Brightened the exterior model's lightmap for the panels so they can be seen through the canopy glass.

CHANGE LOG
07/17/11
===========
1. Multi-Player now works correctly. It is no longer flooding the server with repeated events.

2. Afterburner System should now be SP2 complaint.

3. Modified Gear Warning to use %N1 rather than power lever.

4. Cross-Feed System now working correctly. Shift-4 to bring up a digital test gauge to verify if you like. This

will be removed from the release of course.

5. Fuel Flow needles on aft panel now working properly.
 
You must log in or register to reply here.
Back
Top