• Please see the most recent updates in the "Where did the .com name go?" thread. Posts number 16 and 17.

    Post 16 Update

    Post 17 Warning old domain name stealing credentials

  • Special Server Maintenance

    Just when you think you have everything running some what better...

    You get a message from the Hosting company. Short story they need to move us to a new server. I have been working with them to plan a good date for all concerned. Here is what we have come up with as a schedule.

    1. November 4th 17:00 -5UTC shut off the forums and start backup proceedures. During this time there will be no access to the forums or the Resource Section.
    2. November 5th Continue with Backups and download same until complete.
    3. November 6th 7:00 turn over server to hosting company to move system to new server
    4. November 7th - 8th restore backups and upgrade forum software.

    If all goes well we should be back online on November 8th.

    To keep you updated we will post updates on AVSIM forums.

    Thank you for your support.

Screenshots!

But see http://www.sim-outhouse.com/sohforums/showthread.php/22980-tail-wheel-contac-point?highlight=moling and http://www.sim-outhouse.com/sohforums/showthread.php/22980-tail-wheel-contac-point?highlight=moling which mentions also has a post

You'll find the is4g moling fixes at http://web.archive.org/web/200705141...i.com/misc.htm

If you end up following a link and get to the ppc site that replaced is4g, then edit the URL to replace the date (20070514132754 above) with a "*" character. That will give you a list of all available versions of the page, then you can get what you want through trial and error.

I guess you might be able to work out what changed by comparing the files provided by Corrado with the originals?
 
Changed the balance, wheel contact points, engine power, and rudder/elevator control effectiveness.

It was a challenge in that I initially got the static and take-off positions working, but it always submarined on landing. Fixing the landing, and it was stuck in place at take off roll. Fixing take off and landing and it didn't want to fly straight and level even with major trim adjustments. It took all evening to find the right combination of everything to make it airworthy.

p.s.
I also set the start-up effects in the xdp file to match the engine nacelle locations.

 
Last edited:
Big Beautiful Beast

2NXJBcD.jpg
 
Havoc II WIP pit

John will be pissed at me but even his WIP stuff is too good not to tease.
 

Attachments

  • havi.jpg
    havi.jpg
    60.8 KB · Views: 17
You must log in or register to reply here.
Back
Top